Wing Helper 1.3.0 Beta 3 Released!

Read-only group with messages from the makers of Wing Helper
Post Reply
User avatar
alex.pozgaj
Posts: 86
Joined: Tue 29. Sep 2015, 20:08

Wing Helper 1.3.0 Beta 3 Released!

Post by alex.pozgaj » Thu 5. Jan 2017, 22:25

Dear friends of Wing Helper,

we are happy to announce the second public beta version of the upcoming Wing Helper 1.3.0! Our Alpha Team already did a great job in making sure that this version is working correctly. In this beta test phase, we are looking forward to finding - with your help - and fixing the last remaining bugs and issues. Please note, that Beta 2 was only an internal version, which was not released.

Please make sure to read the announcement of 1.3.0 Beta 1 first.

The changes introduced with 1.3.0 Beta 3 are:
  • HOT: Joiners now also working between outer panels
  • Allow building tabs to be positioned +/-150mm from the edge
  • Version check under OSX (Mac) improved
  • Fix for joiner spars when root / tip twist is used
  • "Modify Rib" is now active until explicitely de-activated (i.e. you don't have to say "Modify Rib" for every single rib)
  • "Cancel" added to the program exit dialog
  • PDF output of the entire wing improved
This version can be freely downloaded and installed. If you already have a valid Wing Helper license, you will be able to work with 1.3.0 Beta 3 as if it were an official final release. If you don't own a Wing Helper license yet, you will see the same restrictions with respect to DXF and PDF export as with any officially released version.

This beta version is valid until 2017/01/30. At latest at that date, it will be replaced by either a new beta version, or by the official version 1.3.0, depending on the findings.

Best regards,

Aleksandar Pozgaj
Aleksandar Pozgaj
Wing Helper e.U.

Post Reply